Where To Discharge Water Softener Backwash

Make sure the discharge line is properly air gapped to prevent cross contamination.

Where to discharge water softener backwash.

Use a separate drywell or floor drain to receive water softener backwash. Connect to municipal water supply if available so that your water will arrive already properly conditioned and therefore not require softening. However if the water treatment system is installed after the septic system is built and the leach field is not designed to accommodate the backwash water then alternate methods of disposal may be used. If local code allows i would recommend diverting the softener backwash water to another location outside of the septic system.

The treatment system can help with many problems associated with drinking water hardness bacteria odor high levels of iron etc. If connecting the softener discharge to. Practices for the discharge of water softener backwash brine to avoid potential problems with onsite wastewater treatment systems owts and impacts to surface water and groundwater quality. Contrary to what some people say water softener backwash poses a problem not only to septic tanks and drainfields but also to advanced treatment systems.

This is a large surge load which can upset the settling process in the tank. This causes two problems. Water softener backwash many home owners who use a well to get their water opt to have a water treatment system. The dep is working on a general permit which would allow the discharge of water softener backwash into a dedicated subsurface disposal system but not into a septic system.

A water softener dumps from 50 gallons to 100 gallons of water into the system when it regenerates. When the water softener resin is backwashed two or three times a week concentrated brine enters the wastewater stream as a slug of 38 to 112 gallons each backwash cycle. The current plan is to present this draft to other stakeholders such as water treatment vendors the ct onsite wastewater recycling. During a backwash of a water softener system water runs through a resin tank upward.

These problems are caused by high levels of chloride and other ions in the backwash brine from water softener regeneration.