Waterstop For Existing Concrete Joints

All types of waterstops to prevent liquid leaking.

Waterstop for existing concrete joints.

Hydrotite is the ideal hydrophilic waterstop for pre cast and cast in place concrete construction joints. So waterstops are designed as a fluid tight diaphragm embedded in or running along the joints to solve these problems. Contraction construction and expansion joints. This filling property is used to seal the concrete joints.

Special profile fabrications are available for columns and pipe. Pvc336l small l shaped retrofit waterstop for non moving construction joints. Concrete structures are only as watertight as the waterstops that join them. Great choice for containment curbs on slabs.

A waterstop installed in concrete joints is an important component of an overall waterproofing design to protect below grade portions of a concrete structure. Hydrotite is suitable for floor joints wall joints tee butt joints or side by side joints between new and existing structures large concrete refacing and rehabilitation projects. Cold joints is a good design practice for building foundations with or without a positive side waterproofing membrane. It is ideal for constructing a new containment curb or wall to an existing slab or joining a new slab to an existing wall.

Krytonite swelling waterstop is a synthetic rubber waterstop that uses swelling pressure to seal concrete construction joints and stop water. Often the preferred choice for containment curbs on slabs. They include but are not limited to joint type and joint. Structures such as water treatment plants reservoirs locks dams and below grade facilities most likely have a waterstop system in place.

This waterstop actually compression seal the system thus filling the cracks and the voids in the concrete. Retrofit waterstop is designed to provide a fluid tight seal between existing and new concrete construction without resorting to the labor intensive and structurally destructive saw cut and grout method. Conseal s cs 231 is designed for use in the following general applications. These products use in construction joints i e.

Used for joining new to existing concrete. One of the challenges in installing this system is that the bentonite must be maintained dry until it is poured into the joint which has to be sealed. Retrofit waterstop is designed to provide a fluid tight seal between existing and new concrete construction without resorting to the labor intensive and structurally destructive saw cut and grout method. Both vertical and horizontal concrete construction joints between dual concrete pours between new and existing concrete sealing irregular surfaces and around through wall penetrations for plumbing and utility pipe.

Several factors must be considered when selecting a waterstop.